Inventory

E. PCS 75-25-25

PCS 75-25-25

DWG Files

Manufacturer's Specification

The PCS 75-25-25 is standard extruded aluminum alloy 6063 T5 and is .050 thick. PCS 75-25-25’s shall have a standard Clear Anodized finish. Mill and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details.

Install all PCS 75-25-25’s using full ten-foot lengths wherever possible. Attach PCS 75-25-25’s to the framing with nails, screws, or other approved fastening methods. All PCS 75-25-25’s must be cut accurately and installed with tight, neat joints. All   nailing flanges must be covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trims.

For MSDS report, click "More Information (PDF)" above.

 

Channel Alignment Splices

PCS 75-25-25’s are now available with Alignment Splices. Alignment Splices are suitable for butt joints, intersections, corners, and radius work. Refer to Alignment Splices for details. Flannery also offers Vinyl Connector Clips for joining one PCS 75-25-25 to another.

 

                

 Installation Detail

 Inside and Outside Corners            

Flannery offers prefabricated intersections as well as inside and outside corners for the PCS 75-25-25.   Prefabricated intersections and corners are mitered and then welded at the nailing flanges. Alignment Splices are also available for aligning inside and outside corners.

                                                                

   

 

 

 

 

                   

  

 

 

 

 

Radius Shapes

 

               

 

 

 

 

 

        

 

 

 

 

 

 

 

 

Sealant & Vinyl Connector Clips

1. Sealant is required at all butt joints.

2. Vinyl Connector Clips are required for Flannery's PCS 75-25-25.

3. Use Flannery's Aluminum Alignment Splices or Vinyl Connector Clips to align Moldings.

 

 

 

 

 

 

 

 

 

 

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.