Inventory

C. Drip Screed DS-875

Drip Screed DS-875

DWG Files

Manufacturer's Specification

Drip Screeds (DS-875) are standard extruded aluminum alloy 6063 T5 and are .050 thick. Drip Screeds shall have a standard Clear Anodized finish. Mill and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details. For radius shapes, see below and for venting options, please see the Venting Options link.

Install all Drip Screeds using full ten-foot lengths  wherever possible. Attach Drip Screeds to the framing with nails, screws, or other approved fastening methods. All screeds must be cut accurately and installed with tight, neat joints. All nailing flanges must be covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trims.

For MSDS report, click "More Information (PDF)" above.

         

 Channel Alignment Splices

Flannery is the first manufacturer to offer splices for Drip Screed. When used, Alignment Splices allow for clean and neat butt joints.

 

 

 

 

Installation Detail

 

                                        

Drip Screed DS-875 with Vent Slots (Click Here)

Inside and Outside Corners

Flannery offers prefabricated inside and outside corners for Drip Screeds. Prefabricated corners are mitered and then welded at the nailing flanges.  Alignment Splices are also available for aligning inside and outside corners.

                                                                

 

 

 

 

 

 

 

Drip Screed Radius Shapes

                                         

 

 

 

 

 

   

 

 

 

                                                                      

 

 

 

 

 

       

 

 

 

 

  

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.