Inventory

V. Smooth Finish Drip - SFD

Smooth Finish Drip - SFD

DWG Files 

Manufacturer's Specification

Smooth Finish Trims (SF) are standard extruded aluminum alloy 6063 T5 and are .050 thick. Smooth Finish Trims shall have a standard Clear Anodized finish. Mill and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details. Intersections, corners, and radius shapes are also available.

Install all Smooth Finish Trims using full ten-foot lengths wherever possible. Attach Smooth Finish Trims to the framing with nails, screws, or other approved fastening methods. All Smooth Finish Trims must be cut accurately and installed with tight, neat joints. All nailing flanges must be covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trims.

For MSDS report, click "More Information (PDF)" above.

 

 

Installation Detail

 

Inside & Outside Corners

 

 

 

 

 

 

 

Radius Shapes

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.