Inventory

Vent Screeds

Vent Screeds

 Manufacturer's Specification

It is possible to punch Vent Slots into many of Flannery’s Aluminum Extrusions, thus providing the needed ventilation for any project. All Vent Slots are 1/8” wide and 1” long. They are configured at 1½” on center lengthwise and ½” on center laterally. Each row of Vent Slots lengthwise provides approximately one-square inch of vented area per lineal foot (see Vent Area Graph below).

Attach Vent Screeds to the framing with nails, screws, or other approved fastening methods. To ease installation, Flannery offers Aluminum Alignment Splices for most of its Vent Screeds (see page 2). All Vent Screeds must be cut accurately and installed with tight, neat joints. All nailing flanges must be covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any  aluminum trims. Please specify Flannery Product Code along with the phrase “with Vent” (i.e. “PCS 75-200 with Vent”) when ordering Vent Screeds.

For MSDS report, click "More Information (PDF)" above.

         

 

   

 

Vent Area Graph

Reveal Width	Vent Slots	Vent Area Per Lineal Foot Approx
1/2"	1	1 sq. inch
3/4"	1	1 sq. inch
7/8"	1	1 sq. inch
1"	1	1 sq. inch
1 1/2"	2	2 sq. inch
2"	3	3 sq. inch
2 1/2"	3	3 sq. inch
3"	5	5 sq. inch
4"	7	7 sq. inch
6"	8	8 sq. inch

 

 

 

 

 

 

 

 

 

 

 

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.