Inventory

F. Smooth Finish E.I.F.S. Vent - SFEV

Smooth Finish E.I.F.S. Vent - SFEV

DWG File

Manufacturer's Specification

Flannery’s E.I.F.S Soffit Vents are standard extruded aluminum alloy 6063 T5 and are .050 thick. They are available in Mill, standard Clear Anodized, and Alodine finishes. Other factory finishes and custom paint orders are also available. Refer to Finishes for details. All Vent Slots are 1/8" wide and 1” long. They are configured at 1½” on center lengthwise and ½” on center laterally. Each row of Vent Slots lengthwise provides approximately one-square inch of vented area per lineal foot (see Vent Area Graph).

E.I.F.S. Vents must not be unstalled in areas where there is solid framing, since this may block some or possibly all of the vent slots. Attach E.I.F.S. Soffit Vents to the framing with nails, screws, or other approved fastening methods. Fasteners should be staggered the entire length of the trim. All Vents must be cut accurately and installed with tight, neat joints. All butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trim. All butt joints must be sealed.

For a Material Safety Data Sheet (MSDS report), click here.

                                                                                    

 

 

Reveal Width	Vent Slots	Vent Area Per Lineal Foot Approx.
3"	5	5 sq. inch

 

 

 

Installation Detail

 

 

 

 

 

 

 

 

 

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.