Veneer Plaster J-Mold

Trim Purpose

Specs, MSDS, and LEED Information for Flannery Trims & Products

Flannery’s Veneer Plaster J-Mold is an edge trim that allows the installer to attach it to the framing prior to the installation of the gypsum board without losing the advantage of being able to tape and mud the trim to the drywall. Most commonly known as “Drywall J-Bead”, the Veneer Plaster J-Mold offers an even greater bevel for joint compound than typical drywall trims provide. This additional bevel to the taping flange allows for the application of the veneer plaster for a clean and crisp edge to the wall system.

Product Details

Flannery’s Veneer Plaster J-Molds are standard extruded aluminum alloy 6063 T5 and are .050” thick. Aluminum trims come in 10′ lengths and shall have a standard Mill Finish for field priming and painting unless specified otherwise. Clear Anodized and Chem-film finishes, as well as other factory finishes and custom paint orders are available. Click on Info Tab above for Factory Finishes.

Product Details-

Veneer Plaster J Mold Dimensions 300x268 - Veneer Plaster J-Mold
Part No. “A” Width Stock Item
VPJ 625 5/8″ No

 

 

Attach Veneer Plaster J-Molds through the attachment flange to the framing with nails, screws, or other approved fastening methods. Insert drywall into the gap behind the tapeable flange and then apply compound joint and tape as needed with the veneer plaster coat to follow. All drywall trims must be cut accurately and installed with tight, neat joints. Manufacturer recommends that a carbide tip blade along with blade lubricant be used when cutting any aluminum trim.


SJM Intallation 550x396 - Veneer Plaster J-Mold