Drywall End Enclosure - DWE

DWG Files

Manufacturer's Specification

Drywall End Enclosures (DWE) are standard extruded aluminum alloy 6063 T5 and are .050 thick. Flannery offers two sizes of End Enclosures, a 3 3/4” and a 4 7/8" enclosure. End Enclosures shall have a standard Mill finish. Clear Anodized and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details.

Attach End Enclosure through the taping flanges to the drywall and framing with nails, screws, or other approved fastening methods. All End Enclosures must be cut accurately and installed with tight, neat joints. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any  aluminum trims.

For MSDS report, click "More Information (PDF)" above.    

Installation Detail

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also reccommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.