Reveals with Built-In Weep

(Weeping Reveals)

DWG Files

Manufacturer's Specification

Reveals with Built-In Weep (Patent #6,374,559 B1) are standard extruded aluminum alloy 6063 T5 and are .050 thick. Reveals with Built-in Weep shall have a standard Clear Anodized finish. Mill and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details.

Install all Reveals with Built-in Weep over building paper on vertical surfaces using full ten-foot lengths wherever possible. Attached reveals to the framing with nails, screws, or other approved fastening methods. The next horizontal layer of building paper should overlap the 2" nailing flange.  All reveals must be cust accurately and installed with tight, neat joints. Vinyl Connector Clips are available to ease installation and align one piece of Reveal to another. All nailing flanges must be covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trims.

For MSDS report, click "More Information (PDF)" above.

Part No.	"A" Depth	"B" Width
PCSW 50-50	1/2"	1/2"
PCSW 50-75	1/2"	3/4"
PCSW 50-100	1/2"	1"
PCSW 50-150	1/2"	1 1/2"
PCSW 50-200	1/2"	2"
PCSW 75-50	3/4"	1/2"
PCSW 75-75	3/4"	3/4"
PCSW 75-100	3/4"	1"
PCSW 75-150	3/4"	1 1/2"
PCSW 75-200	3/4"	2"
PCSW 75-300	3/4"	3"

   

Installation Details

Patent #6,374,559 B1

Intersections and Corners

Sealant & Vinyl Connector Clips

1. Sealant is required at all butt joints.

2. Vinyl Connector Clips are required for Flannery's Reveals with Built-in Weep.

3. Use Flannery's Vinyl Connector Clips to align moldings.

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.