Door and Window Drip

DWG Files

Manufacturer's Specification

The Door and Window Drip (WD) is standard extruded aluminum alloy 6063 T5 and is .050 thick. The Door and Window Drip shall have a standard Clear Anodized finish. Mill and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details.

Install all Door and Window Drips over the window flashing. Attach Door and Window Drips to the framing with nails, screws, or other approved fastening    methods. The next horizontal layer of building paper should overlap the nailing flange. All Door and Window Drips must be cut accurately and installed with tight, neat joints. All nailing flanges must be  covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trims.

For MSDS report, click "More Information (PDF)" above.

Part No.	"A" Depth	"B" Width
WD 75	3/4"	3/4"
WD 200	3/4"	2"

Installation Details

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.