2-Piece Drip Mold

 DWG Files

Manufacturer's Specification

Part A and Part B of the Drip Mold are standard extruded aluminum alloy 6063 T5 and are .050 thick. Drip Molds shall have a standard Clear Anodized  finish. Mill and Alodine finishes as well as other factory finishes and custom paint orders are available. Refer to Finishes for details. For venting options, click on the Venting Options link.

To ease installation, the installer should strike a line along the soffit and then attach Part A with its nailing flange along that line. Once the installer has fastened Part A to the soffit then Part B can be inserted around Part A and up against the facia. Attach Part A and Part B of the Drip Mold to the framing with nails, screws, or other approved fastening methods. Manufacturer recommends that all joints be staggered. All Drip Molds must be cut accurately and installed with tight, neat joints. All nailing flanges must be covered with lath and all butt joints must be sealed. Manufacturer recommends that a carbide tip blade along with lubricant be used when cutting any aluminum trims.

For MSDS report click "More Information (PDF)" above.

Part No.	"A" Depth	"B" Width	Venting Available
DS 75-150	3/4"	1 1/2"	Yes
DS 75-200	3/4"	2"	Yes
DS 75-300	3/4"	3"	Yes
DS 75-400	3/4"	4"	Yes

Installation Detail

2-Piece Drip Mold wit Vent Slots (Click Here) 

Drip Screed and Drip Mold Radius Shapes

This website presents general guidelines and suggestions for the installation of Flannery trims and products. The purpose of these general guidelines and suggestions is to aid in a successful drywall or stucco finish based on the Uniform Building Code and industry standards. No website or catalog can address all of the unique specifics or installation details that occur from one project to another. Flannery recommends that every installer be familiar, or become acquainted with, common drywall and stucco trim installation practices before installing any of Flannery's many trims and products. Flannery also recommends that the specifying architect, engineer, and general contractor be consulted with as well. This website replaces and renders obsolete all previous publications by Flannery; including catalogs, pamphlets, or other forms of literature.