LED Ceiling Mold (LCM)

Trim Purpose

Specs, MSDS, and LEED Information for Flannery Trims & Products

Flannery’s LED Drywall Ceiling Trim (LCM) creates a linear light reveal at the top of a vertical gypsum wall where it meets a gypsum board ceiling. The LED Ceiling Trim is installed with 5/8” thick gypsum board and is available in varying heights. Flannery’s LED Drywall Ceiling Trim comes with a frosted diffuser and allows for a ½” wide or smaller LED strip to be applied to the reveal’s side wall (LED’s and wiring are not provided).

Category:

Product Description

LED Drywall Ceiling Trims are standard extruded aluminum alloy 6063 T5 and are .050” thick. Flannery’s LED Reveals come in 10′ lengths and shall have a standard Mill Finish for field priming and painting unless specified otherwise. Clear Anodized and Chem-film finishes, as well as other factory finishes and custom paint orders are available. Click on Info Tab for Factory Finishes.

Part No. “A” Depth “B” Width Stock Item
LCM 625-200 5/8″ 2″ Yes
LCM 625-300 5/8″ 3″ Yes
LCM 625-400 5/8″ 4″ Yes
05 LED Ceiling Mold LCM Scale Dimen R2 BjB - LED Ceiling Mold (LCM)

Attach Part B of the LED Drywall Ceiling Trim through the taping flange to the gypsum ceiling and framing with screws where it meets the vertical wall. Part A is then laid over the edge of Part B and the vertical gypsum wall and then fastened through its flange to the framing with screws. All reveals and diffusers must be cut accurately and installed with tight, neat joints. Manufacturer recommends that a carbide tip blade along with blade lubricant be used when cutting any aluminum trim. The frosted diffuser should be cut with a double edged blade to reduce cracking. Installer must consult with LED manufacturer for LED light strip installation and wiring procedures and methods.
05 LED Ceiling Mold LCM Install Detail 1000 R2 BjB 01 758x1024 - LED Ceiling Mold (LCM)

Flannery offers pre-fabricated Inside and Outside Corners for intricate wall designs that utilize an LED reveal around corners. Pre-fabricated corners are mitered and then welded at the nailing flanges. Factory welded corners come with 6” legs, however custom leg lengths can be ordered.

In addition to pre-fabricated corners, Flannery also provides wiring notches in the side wall of the aluminum ceiling mold and behind the diffuser to allow for the wiring of the LED strips to return back to the power source. These notches are concealed once the diffuser is in place.

05 LED Ceiling Mold LCM 3D In Outside Corner 1550 R4 BjB 01 1 1024x330 - LED Ceiling Mold (LCM)