LED Base Molding (LBM)

Trim Purpose

Specs, MSDS, and LEED Information for Flannery Trims & Products

Flannery’s LED Drywall Base Molding (LBM) creates a linear light reveal at the bottom of a vertical gypsum wall. The LED Drywall Base Mold is installed with 5/8” thick gypsum board and is available in varying heights. Flannery’s LED Drywall Base Mold comes with a frosted diffuser and allows for a ½” wide or smaller LED strip to be applied to the reveal’s side wall (LED’s and wiring are not provided).

Category:

Product Description

LED Drywall Base Moldings are standard extruded aluminum alloy 6063 T5 and are .050” thick. Flannery’s LED Reveals come in 10′ lengths and shall have a standard Mill Finish for field priming and painting unless specified otherwise. Clear Anodized and Chem-film finishes, as well as other factory finishes and custom paint orders are available. Click on Info Tab for Factory Finishes.

Part No. “A” Depth “B” Width Stock Item
LBM 625-200 5/8″ 2″ Yes
LBM 625-300 5/8″ 3″ Yes
LBM 625-400 5/8″ 4″ Yes
04 LED Base Mold LBM Scale Dimen R3 BjB - LED Base Molding (LBM)

Attach the LED Drywall Base Molding Part A through the taping flange to the drywall and framing with screws or other approved fastening methods. Part B is inserted up and in behind Part A and glued to the substrate creating the base reveal. All reveals and diffusers must be cut accurately and installed with tight, neat joints. Manufacturer recommends that a carbide tip blade along with blade lubricant be used when cutting any aluminum trim. The frosted diffuser should be cut with a double edged blade to reduce cracking. Installer must consult with LED manufacturer for LED light strip installation and wiring procedures and methods.
04 LED Base Mold LBM Install Detail 1000 R1 BjB 931x1024 - LED Base Molding (LBM)

Flannery offers pre-fabricated Inside and Outside Corners for intricate wall designs that utilize an LED reveal around corners. Pre-fabricated corners are mitered and then welded at the nailing flanges. Factory welded corners come with 6” legs, however custom leg lengths can be ordered.

In addition to pre-fabricated corners, Flannery also provides wiring notches in the side wall of the aluminum base molding and behind the diffuser to allow for the wiring of the LED strips to return back to the power source. These notches are concealed once the diffuser is in place.

04 LED Base Mold LBM 3D Pre Fabricated Corners R3 BjB 1024x496 - LED Base Molding (LBM)