Acoustical Ceiling Cloud Transition (ACCT)
Specs, MSDS, and LEED Information for Flannery Trims & Products
Flannery’s Acoustical Ceiling Cloud Transition (ACCT) allows for the transition from one suspended acoustical ceiling plane to an upper or lower ceiling plane that also utilizes acoustical tiles. The Cloud Transition gives the designer the ability to integrate two ceilings at differing heights to be connected preventing the hanger wire and ductwork of the lower ceiling from being seen from below. Flannery offers the Cloud Transition trim in several sizes for varying ceiling level heights. Each Acoustical Ceiling Cloud Transition trim comes with attachment clips and splices to ease its integration into the suspended ceiling system.
Flannery’s Aluminum Strata Cloud Trims are standard extruded aluminum alloy 6063 T5 and have a typical .060” nominal wall thickness or greater. Strata Cloud Trims come in 10’ lengths and shall have a standard Mill Finish (for field priming and painting) or a factory Kynar “Cloud White” paint. Other factory finishes including liquid or powder coated paint, Primer, Chem-Film and Anodizing are available.
Connect Acoustical Ceiling Cloud Transition trims to the suspended ceiling grid using the Ceiling Grid Trim Clips included. Rotate the Ceiling Grid Trim Clip into the slots on the back of the Cloud Edge trim and tighten the lock screw. Then attach the Ceiling Grid Trim Clip to the acoustical ceiling grid.
Repeat these steps again when attaching the lower half of the Acoustical Ceiling Cloud Transition trim to the other level of the acoustical ceiling grid. Use the included Ceiling Cloud Trim Splices to connect one piece of trim to the next for level and clean butt joints. All Cloud Edge Trims must be cut accurately and installed with tight, neat joints.
Flannery offers prefabricated Inside and Outside Corners for intricate ceiling designs that utilize our Strata Acoustical Ceiling Cloud Transition trim. Prefabricated corners are factory mitered and then welded together to prevent separation during the edge trim installation. These welded corners also allow the installer to maintain a straight and true layout of any rectangle or square ceiling. Factory welded corners come with 8” legs in each direction, however, custom leg lengths can be ordered. Factory cutting and mitering for custom ceiling projects are also available.